In this video I show you how I make my own "test lights" of various amperage's that can be used to substitute for a component on the vehicle that has failed. These range any where from .25amp to 4.5amp and can be used to replace failed fuel pumps, actuators, lights, solenoids etc. so you can preform circuit integrity tests. -Enjoy!

CHECK OUT OUR "SMA SWAG" STORE! Go on Teespring and get your very own SMA merch!
[ Ссылка ]

If you don't like Patreon feel free to use the "PayPal Me" link: [ Ссылка ]

The South Main Auto Amazon Store:
[ Ссылка ]

AES Wave Automotive Diagnostic Tools: [ Ссылка ]

Thank you for all the continuing support!
--Eric & Vanessa O.

Feel like sending some swag to SMA because you love the videos but don't know where to send it?

Just ship it here:

South Main Auto Repair
47 S. Main St
PO Box 471
Avoca, NY 14809


Disclaimer:
Due to factors beyond the control of South Main Auto Repair, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. South Main Auto Repair assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. South Main Auto Repair recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of South Main Auto Repair, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained

свернуть