Hi, this project is inpired by "Leo knapp" big thanks to him
(check it out: [ Ссылка ])
Find my remix here: [ Ссылка ]
I changed the proportions to adapt this surfboard fin to a wakesurf board that is smaller.
The result is a fin of 9 cm high (3.5"), 13,6 cm long (5") and 5mm thickness fin.
Why 5mm ? Because the FCS required fins with a plug sytem with 6-7mm thick, so you can fiber glasse the 3d print both side and end up with a 6-7mm thick fin, strong as hell !
Leave a comment, I hope you enjoy !
