HOW TO install a Fingerprint Door Lock yourself | Install a door lock with Keypad | Unboxing TEEHO Fingerprint Door Lock | Keyless Entry
Unboxing TEEHO Fingerprint Door Lock
#DoorLock #Fingerprint #Amazon
#Unboxing #Howto #Review #WhatFeatures #StepbyStep #SetUp #Whatsinthebox #FatmanUnboxing #FatmanHowto #USA #Shorts #Reels #tiktok #teeho @teeho4053
Fingerprint Door Lock - TEEHO TE002 Keyless Entry Door Lock with Keypad - Electronic Deadbolt Keyed Entry - Front Door Lock Sets - Combination Door Lock - Easy Installation - Satin Nickel
[ Ссылка ]
4 AA (1.5V) alkaline batteries (not included)
Installation Instructions
1. Prepare the door and check dimensions
Measure to confirm that the hole in the door is 2-1/8" (54mm).
Measure to confirm that the backset is either 2-3/8" or 2-3/4" (60 or 70mm).
Measure to confirm that the hole in the door is 1" (25mm).
Measure to confirm that door thickness is between 1-3/8" to 2" (35mm to 50mm).
2. Choose faceplate
Is the slotted hole centered in the door hole?
Rotate and pull the latch as shown to extend latch.
3. Install latch and deadbolt
IMPORTANT: Keep the latch in unlocked position before installation.
4. Install exterior assembly
Route the cable below the latch.
IMPORTANT: Bolt must be in unlock position.
Note horizontal orientation of torque blade.
Route the cable through the hole in the mounting plate.
Secure the mounting plate with the supplied screws.
5. Install interior assembly
IMPORTANT: Do not load batteries until lock is completely installed.
Remove the battery cover.
Connect the cable and ensure tight cable connection.
Rotate the Thumb turn in vertical position and insert the horizontal orientation of torque blade into the interior assembly lock switch.
Secure the interior assembly with the supplied screws.
Test the lock by rotating the thumb turn to see if the bolt can be extended and retracted smoothly.
6. Detect left/right hand door installation
IMPORTANT: This step is required and crucial for the lock after installation!
Using only new and non-rechargeable Alkaline batteries which for the best results.
While the door is open and unlock, load 3AA batteries into the interior assembly.
Press and hold the reset button on the interior assembly using the reset tool provided in package.
Keep holding the reset button and load the last battery. Hold the reset button until you hear the long sound of “BEEP”. The lock will automatically go into locking position. This is for the smart lock to memorize the orientation of the door.
FATMAN UNBOXING has made the unboxing video on the internet.
If you like my video, please LIKE, SHARE and SUBSCRIBE my channel.
Subscribe for new videos!
[ Ссылка ]
My Social Media:
Instagram: [ Ссылка ]
Facebook: [ Ссылка ]
Youtube: [ Ссылка ]
TikTok: [ Ссылка ]
#HowTo #Unboxing #Review #WhatFeatures #Setup #Whatsinthebox #stepbystep #FatmanTanawat #FatmanUnboxing @FatmanUnboxing
