Following on from my workbench video, this is how I was able to flatten or surface the using a router and a simple sled made from plywood.

Using a hand plane is a more traditional approach to this but hand planes aren't cheap and I don't own any yet. Further more, I made a pretty rough job of the original glue up which would have made hand planning very hard indeed!

The specific router bit I used:
[ Ссылка ]

Similar bits from Amazon that should do the same job
[ Ссылка ]
[ Ссылка ]

Some of my tools:
Pocket hole jig - [ Ссылка ]
Woodpeckers stainless steel squares - [ Ссылка ]
Planer/Thicknesser - [ Ссылка ]
Cabinet Saw - [ Ссылка ]
Jig Saw - [ Ссылка ]
Circular Saw - [ Ссылка ]
Brad point bits - [ Ссылка ] and [ Ссылка ]
Right angle clamps - [ Ссылка ]

свернуть