We are now diving deeper into the K20 swap in my Toyota Mr2 Spyder (zzw30). You also want to start building your K20 engine for the Kswap in your car? Watch this video to tear down your engine before the regfresh. Let me walk you through a few steps! ENJOY and don't forget to Add me on Insta: @jesse_yaroo
My Instagram: [ Ссылка ]
This video is built like a tutorial for all those who want to give their k20 or k24 a refresh by tearing it down and checking a few essential elements and refresh the parts, where its needed.
This is not a complete rebuild video but gives you a good starting point if you want to go down that road.
Enjoy the video!
If you want to get to the specific chapters of this video with the exact parts, you can check the following timelines:
0.00: Intro
2:30 Engine Harness removal and various sensors
3:26 Water pump, fuel rail and Intake manifold removal
4:20 Exhaust manifold and Valve cover removal
5:14 Inspection of cams and head and oil leaks
6:48 Oil pan removal and lower end inspection
8:01 Oil pan gasket removal and cleaning
9:00 K20 Crank pulley removal (warning, very difficult)
11:46 Timing Chain cover, Timing chain and rails removal
13:47 Oil Pump removal and crankshaft inspection
14:42 Final Conclusion
Thank you very much for watching. A like, a sub, a share is always appreciated!
If you want to buy a sticker to support the channel, send me a DM on instagram ;-)
By the way, have you seen my new website in the making?
[ Ссылка ]
My recommandation:
Watch the whole playlist of this project to fully grasp what and why I am doing it!
My Mr2 Project:
[ Ссылка ]...
How to Swap a 2ZZ Tutorial Playlist:
[ Ссылка ]...
Make sure to subscribe if you want to see the next steps of the Mr2 Build!
#toyota #mr2spyder #k20swap
![](https://s2.save4k.ru/pic/-ocr3WgW_t0/maxresdefault.jpg)