How to configure a new CNC? After building the C-Beam CNC which I got as a mechanical build from a Chinese maker it was time to start with the electronics. It took me a while to understand what components are required and how I should go about it. Because all these details were not available at one place I have decided to write this post in detail to explain them. Hope you enjoy it.

------------------//------------------
Written Tutorial: [ Ссылка ]
Download the schematic: [ Ссылка ]
------------------//------------------
REQUIRED MATERIALS:
Stepper Motor: [ Ссылка ]
TB6600 Stepper Motor Driver: [ Ссылка ]
Arduino Uno: [ Ссылка ]
Power Supply: [ Ссылка ]
Emergency Stop Switch: [ Ссылка ]
Router & Power Switch: [ Ссылка ]
4 Pin Connectors: [ Ссылка ]
AC Power Connector: [ Ссылка ]
C-Beam CNC Mechanical Build: [ Ссылка ]
------------------//------------------
VIDEOS:
Finding stepper motor wires: [ Ссылка ]
GRBL: [ Ссылка ]
Universal Gcode Sender: [ Ссылка ]
Easel: [ Ссылка ]
------------------//------------------
FOLLOW ME ON:
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]
------------------//------------------
MORE PROJECTS TUTORIALS and POSTS
[ Ссылка ]
------------------//------------------
MUSIC: Bit Quest (incompetech.com)
------------------//------------------

свернуть