Using my K40 laser, I was able to make professional looking switch panels. This particular switch panel is going to be installed in our Class A motorhome. I'll have another video detailing that project.

12"x12"x1/8" (3mm) Baltic Birch Plywood [ Ссылка ]

Dust-Off Disposable Compressed Gas Duster [ Ссылка ]

Delvie's Plastics Frosted White Sheet (12"x12"x1/8") [ Ссылка ]

Rust-Oleum 249127 Painter's Touch 2X Ultra Cover Flat Black Spray [ Ссылка ]

Delvie's Plastics black/white laser engrave plastic (1/16") [ Ссылка ]


* My preferred material: TroLase (Black/White, 2 Qty x 12" x 12" x 1/8") [ Ссылка ]

Ordered: TroLase Metallic (Brushed Aluminum/Black, 12" x 20" x 1/8") [ Ссылка ]
Ordered: TroLase (English Walnut/White, 2 Qty x 12" x 12" x 1/16") [ Ссылка ]

Settings: Raser Engrave 4mA @ 100 mm/sec., air assist OFF. Cut 10mA @ 4 mm/sec, air assist ON. Your settings may vary, so experiment on a small piece before starting a large project.

As an Amazon Associate I earn from qualifying purchases.

свернуть