In this video, I go over how to set up an OC200 Omada Hardware Controller for the first time. This device is just a small piece of equipment that hosts the Omada controller software. It is much more convenient than needing to run the software on a PC or Server 24/7.
I cover how to connect to, and set up the device for the first time as well as how to add a few access points to it. Finally, we cover how to upgrade the firmware on the device.
00:00: Intro
01:11: Connecting the OC200
03:32: Discovery and Configuration via Mobile App
08:35: Connecting to OC200 via Web Browser
09:34: Connecting Access-Points
11:10: Checking the Fallback IP
12:10: Adopting Access-Points
14:35: Upgrading Controller Firmware
17:29: Differences in Old and New Controller Firmware (V5.4 to V5.12)
18:59: Upgrading Access-Point Firmware (not needed in this video)
19:55: Re-naming Access-Points
20:25: Outro
