This was kind of a fun one that you might find useful someday like I did.

Esptool git reference: [ Ссылка ]
Flash chip datasheets: [ Ссылка ]

Here's all of those commands you can use as a starting point and note that on windows, things will be slightly different. Just follow the same steps and you should be good:

Read from Adafruit Huzzah board (4MB):
/Users/kevindarrah/Library/Arduino15/packages/esp32/tools/esptool_py/2.6.1/esptool.py --port /dev/cu.usbserial-01D5ECE0 --baud 921600 read_flash 0 0x400000 adafruit.bin

Write back to Adafruit Huzzah:
/Users/kevindarrah/Library/Arduino15/packages/esp32/tools/esptool_py/2.6.1/esptool.py --chip esp32 --port /dev/cu.usbserial-01D5ECE0 --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 80m --flash_size detect 0x0 /Users/kevindarrah/adafruit.bin

Get Flash ID for size:
/Users/kevindarrah/Library/Arduino15/packages/esp32/tools/esptool_py/2.6.1/esptool.py --port /dev/cu.usbserial-DA00Y7QG --baud 921600 flash_id

Read trigBoard (16MB):
/Users/kevindarrah/Library/Arduino15/packages/esp32/tools/esptool_py/2.6.1/esptool.py --port /dev/cu.usbserial-DA00Y7QG --baud 230400 read_flash 0 0x1000000 trigBoardbackup.bin

Write trigBoard:
/Users/kevindarrah/Library/Arduino15/packages/esp32/tools/esptool_py/2.6.1/esptool.py --chip esp32 --port /dev/cu.usbserial-DA00Y7QG --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 80m --flash_size detect 0x0 /Users/kevindarrah/trigBoardbackup.bin

Tindie link to trigBoard: [ Ссылка ]

Thanks to all the Patrons for dropping a few bucks in the tip jar to help make these videos happen!
[ Ссылка ]

Twitter: [ Ссылка ]

For inquiries or design services:
[ Ссылка ]

свернуть