If you’re interested in building this project, check out the links below of the items I used in the build (not all items are exactly what I used, but are similar)(As an Amazon Associate I earn from qualifying purchases):
Laguna 6” Jointer [ Ссылка ]
Dewalt DW735 Planer [ Ссылка ]
Drill Press [ Ссылка ]
Forstner Drill Bit Set [ Ссылка ]
Irwin 6” Quick Grip Clamps [ Ссылка ]
Irwin 24” Bar Clamps [ Ссылка ]
Irwin 6” Bar Clamps [ Ссылка ]
Irwin 12” Bar Clamps [ Ссылка ]
Bessey 40” Parallel Clamps [ Ссылка ]
Machinist Square Set [ Ссылка ]
Kreg K4 Pocket Hole Jig [ Ссылка ]
Kreg 1¼” Pocket Hole Screws [ Ссылка ]
Dewalt 20v Cordless Drill [ Ссылка ]
CA Glue Medium [ Ссылка ]
JB Clearweld Epoxy [ Ссылка ]
Feather Board [ Ссылка ]
Window Weather Strip [ Ссылка ]
Foam Weather Strip [ Ссылка ]
Leather Contact Cement [ Ссылка ]
Acid (Glue) Brushes [ Ссылка ]
Titebond II Wood Glue, 16 oz [ Ссылка ]
Dewalt 20v Cordless Drill [ Ссылка ]
Brass 3 inch hinge [ Ссылка ]
Brass barrel bolt [ Ссылка ]
Tape Measure [ Ссылка ]
Dust Mask [ Ссылка ]
Dewalt Safety Goggles [ Ссылка ]
Ear Plugs [ Ссылка ]
Here is a list of other tools in my shop I used (I am not affiliated with these):
Grizzly G0771Z Hybrid Table Saw [ Ссылка ]
The filters I used are MERV 11 filters and I ordered the from AllFilters.com [ Ссылка ]
After installing the mini split AC unit in the shop I decided to build a filter box to go around it. The filters inside the mini split are not designed to filter out all the saw dust created in a wood shop. Since the space around the mini split is limited it limited me on the filters I could use. I designed the box so that there would be a total of four filters, two 12”x12” on each side and two 12”x20” filters in the front. This should still provide enough air for the unit to function properly.
![](https://i.ytimg.com/vi/2LJrfaFuJa0/maxresdefault.jpg)