Condor Speed Shop Designs and makes track tested & street approved performance parts for BMWs. Suspension bushings, motor mounts, shift knobs, ps deletes & more. Lifetime warranty. Made in the USA.
--
► Subscribe to our channel for more like this.
--
UHMW Offset Control Arm Bushings have the hole off-center to give your car a little more track, caster, and camber. These came as standard equipment on E30 M3s (8/89-later) and 1995 E36 M3 but will work with any E30, E36, Z3.
The OEM rubber control arm bushings were designed for comfort in mind... they were meant to to flex and absorb energy. That’s fine on a docile streetcar but on an all-out street/race machine you want your alignment to stay constant. Condor uses UHMW for this application due to its high rigidity and low coefficient of friction allowing for minimal suspension bushing deflection (geometry change). They are highly-recommended for track cars.
Swapping in E46 control arms into your E30 or E36 will significantly increase negative camber by widening the track width and will also give you more clearance for more steering angle. We've designed them offset to re-center the wheel, and give your e30/e36 the correct caster. They will include a stainless-steel insert that tightly presses over the hex pattern on the E46 control arms. You do not need to grind down your control arms or make any other modifications to your chassis. Please note that you will need to use E36 outer tie rods and E90 inner tie rods when installing in an E30 or E36.
We also stock oem carriers/lollipops, and offer our bushings pre-installed into the carriers. This will save you from needing specialty tools and will allow you (or your mechanic) to perform the install much quicker.
Control Arm Bushings Offset-E46 Conversion for E30 & E36
[ Ссылка ]
Control Arm Bushings Offset-E30, E36 & Z3
[ Ссылка ]
Contact us:
Email: support@condorspeedshop.com
Website: [ Ссылка ]
IG: @condorspeedshop
FB: [ Ссылка ]
Twitter: [ Ссылка ]
Ещё видео!