Buy Now!
New Wheel Bearing & Hub Kit from 1AAuto.com [ Ссылка ]
Worn wheel bearings can cause an annoying noise, premature tire wear, and more. And when replacing a press fit wheel bearing and hub combination, it just makes sense to replace both at the same time. This video shows you how to install a new front wheel bearing and hub on your 2007-2011 Honda CR-V.
• Check here for more videos on the 2007-2011 Honda CR-V [ Ссылка ]
This process should be similar on the following vehicles:
2007 Honda CR-V
2008 Honda CR-V
2009 Honda CR-V
2010 Honda CR-V
2011 Honda CR-V
Tools you will need:
• Phillips Head Screwdriver [ Ссылка ]
• 19mm Wrench [ Ссылка ]
• 10mm Socket [ Ссылка ]
• 14mm Socket [ Ссылка ]
• 17mm Socket [ Ссылка ]
• 18mm Socket [ Ссылка ]
• 19mm Socket [ Ссылка ]
• 22mm Socket [ Ссылка ]
• 36mm Socket [ Ссылка ]
• Brake Caliper Hanger [ Ссылка ]
• Press
• Snap Ring Pliers
• Straight Cutters
• Ratchet [ Ссылка ]
• Socket Driver
• Socket Extensions [ Ссылка ]
• Torque Wrench [ Ссылка ]
• Brake Grease
• Brake Parts Cleaner
• Copper Anti-Seize
• Marker / Writing Utensil
• Paper Towels [ Ссылка ]
• Center Punch [ Ссылка ]
• Floor Jack [ Ссылка ]
• Hammer [ Ссылка ]
• Jack Stands [ Ссылка ]
• Wheel Chocks
• Wire Brush [ Ссылка ]
Subscribe: [ Ссылка ]
Check out our playlist:
Honda CR-V 3rd Generation 2007-2011: [ Ссылка ]
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
