Sealed the remaining interior ribs on the right fuel tank. Feels good getting the tank to this point just demoralizing knowing I have to do it all over again on the left tank. Hope you enjoy.
Here is a link to the tinkercad file I created the cap seal tool from. Hope this helps. [ Ссылка ]
Listed below are my affiliate links to some of the tools you have seen me use on this channel so far. If you are going to buy them anyways then I appreciate the support. Hope you enjoy and leave your questions or comments below.
Silicone Sealant spatulas [ Ссылка ]
C Frame and squeezer yokes [ Ссылка ]
Endoscope [ Ссылка ]
Label printer [ Ссылка ]
Welder [ Ссылка ]
Measuring etc:
Machinist Square [ Ссылка ]
Combination Square [ Ссылка ]
Straight Edge [ Ссылка ]
Angle Finder [ Ссылка ]
Epoxy Resin work:
3M respirator mask [ Ссылка ]
Rubber Gloves [ Ссылка ]
Digital Scale [ Ссылка ]
Mixing cups set [ Ссылка ]
Self Etching Primer [ Ссылка ]
Sanding Block [ Ссылка ]
Rasp [ Ссылка ]
File Set [ Ссылка ]
Sanding Sponges [ Ссылка ]
West Systems Resin kit [ Ссылка ]
Electrical:
Magnifying Lamp [ Ссылка ]
Molex Micro-fit connectors [ Ссылка ]
Cable Snap Bushings [ Ссылка ]
Dupont crimp tool [ Ссылка ]
Helping Hands [ Ссылка ]
Ещё видео!