In this video I break down in great detail the speed at which your car will be going for every 500 engine RPM with each typical rear gear ratio for each gear of the transmission and then reverse it to show engine RPM for every 10mph and each transmission gear. Using this data, hopefully you can decide whether you want a 2.73, 3.08, 3.27, 3.55, 3.73, 4.10, or some other gear in your car. Remember this is the RPM based on no slippage at the torque converter so your actual RPM will be different during acceleration or times when the torque converter is slipping.
3.55 gear: [ Ссылка ]
3.73 gear: [ Ссылка ]
4.10 gear: [ Ссылка ]
#wjhandydad #crownvic #reargear #gearratio #DIY
[ Ссылка ]
Disclaimer:
Due to factors beyond the control of WJ Handy Dad, I cannot guarantee against improper use or unauthorized modifications of this information. WJ Handy Dad assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. WJ Handy Dad recommends safe practices when working on vehicles/homes and or with tools seen or implied in this video. Due to factors beyond the control of WJ Handy Dad, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not WJ Handy Dad.
As an Amazon Associate I earn from qualifying purchases
