After watching Dave_C's video about the #NanoLongRange, I decided to take the plunge and build one myself. This video outlines my experience building this 3D printed DIY drone. For more information about this build and a list of the materials I used, check out my detailed articles:

1. NanoLongRange Build Guide: [ Ссылка ]
2. NanoLongRange Test Flight: [ Ссылка ]
3. NanoLongRange with HD Camera: [ Ссылка ]

Table of Contents:

0:19 - Bill of Materials
1:50 - Extending Motor Wires
2:59 - Buck-Boost Converter and LC Filter
3:04 - Wiring Diagram for Buck-Boost Converter and LC Filter
5:10 - Battery Holder
6:47 - Mounting Peripherals
8:15 - Flight Controller Prep
8:52 - Wiring up Crossfire Receiver
8:59 Wiring Diagram for Crossfire Receiver
9:54 - Wiring up GPS Module
10:02 - Wiring Diagram for GPS module
11:20 - Wiring up Camera
11:27 - Wiring Diagram for Camera
12:00 - Wiring up Video Transmitter
12:08 - Wiring Diagram for VTX
14:08 - Wiring up Capacitor
15:06 - Wiring up Power Leads
17:12 - Frying my Flight Controller Board
18:28 - Power it Up!
19:45 - Configuration in BetaFlight
23:55 - PIDs and VTX Tables
24:41 - Maiden Flight
26:54 - Final Thoughts

Errata:

22:43 - Tramp Protocol should be selected instead of SmartAudio

Successful Builds Using this Guide:

[ Ссылка ]
[ Ссылка ]

NOTE: If you have used this guide and have successfully or unsuccessfully built your own #NanoLongRange, let me know in the comments section and I'll post it here.

I would like to thank Dave_C for the hard work that went into his creative design. Get the files and print your own on Thingiverse - [ Ссылка ]

свернуть