This is my version of an NRF24 for the Flipper Zero. I have tried to make it as small as possible and still easy to make. It uses a 3.3v converter to help reduce the footprint and also mitigates issues some people have had running attachments off the 3.3v GPIO pin as it is also shared with the SD card.
CC1101 DIY
[ Ссылка ]
IR Sniper DIY
[ Ссылка ]
ESP32-CAM DIY
[ Ссылка ]
CASE STL:
[ Ссылка ]
Textured Sheets I used to get patterns on 3D printed cases
Smooth Triangles
[ Ссылка ]
Carbon Fibre
[ Ссылка ]
PARTS I ORDER BELOW:
NRF24 Module
[ Ссылка ]
30AWG Silicone Wire
[ Ссылка ]
Prototype Board
[ Ссылка ]
PCB Board Pins 11.2-11.5mm
[ Ссылка ]
3.3v Converter Board
[ Ссылка ]
SMD LED
[ Ссылка ]
Helping Hand
[ Ссылка ]
Soldering Iron
[ Ссылка ]
If you would like to support the channel, you can do so by the below. All funds will go towards purchasing more parts to make more content for the community.
[ Ссылка ]
