Changing the Oil isn't difficult on this car, however, getting the filter can take a bit of a pain to get to but it can be done with some patience.
Taken from Fiat500USAforum Forum:[ Ссылка ]
1) Lift car front end with jacks and jack stands or wheel ramps.
2) Remove 6 screws so that engine under guard can be removed.
3) Remove engine top cover.
4) Remove 3 screws holding air intake plenum, loosen hose clamp from large hose that routes air from plenum to intake. Wiggle 2 other hoses loose, and take water overflow hose out of clamp at rear of intake plenum. Now, intake plenum can be taken out of the way.
5) Using 27mm socket, loosen oil filter cartridge. I was able to put my ratchet down close to the socket to back the socket out (3/8" ratchet, 3/8 to 1/2 inch adapter to connect to socket). Put paper towel around base of cartridge to catch any oil that might dribble out (only a few drops dribbled down the side). It's important to take the oil filter cartridge off first before draining the oil pan. If not, when you remove the cartridge later, the oil in the cartridge area will drain down into the oil pan.
6) Remove oil pan plug to drain the oil pan.
7) Clean out oil filter cartridge, then install new filter element (comes with new o-ring).
8) Reinstall oil plug. Fill with 4 quarts 5W-30.
9) Reinstall air intake plenum, engine cover, and lower engine guard.
![](https://i.ytimg.com/vi/6n0-EUaJMxs/maxresdefault.jpg)