Here is a quick video on how to test a Starter and Solenoid assembly, using just a screwdriver, jumper wires and a 12v battery. Not the most scientific test but its a good DIY test you can perform before you go out and by a replacement starter for your car.

Here are Links to Tools and Parts Used in the Video:

Jumper Cables: [ Ссылка ]
Alligator Clips: [ Ссылка ]

VIDEO LINKS:

How to Paint a Plastic Bumper Cover: [ Ссылка ]

How to Paint Your Car - Part I: [ Ссылка ]

How to inspect and test inner and outer tie rod ends: [ Ссылка ]

How to Remove and Replace Inner and Outer Tie Rod Ends: [ Ссылка ]

How to Test Your Car's Battery: [ Ссылка ]

How to Test Your Car's Alternator: [ Ссылка ]

How to Test a 3, 4 or 5 Pin Relay without a Diagram: [ Ссылка ]

How to Remove Rust and Polish Chrome in One Step: [ Ссылка ]

If this video helped you out please don't forget to subscribe, give it a thumbs up or if you are feeling generous leaving a tip by clicking the " i " button on the top right corner of the screen. Thank you very much for your support!

Please Consider Supporting My Channel at : [ Ссылка ]

Facebook: [ Ссылка ]
Twitter: [ Ссылка ]
Instagram: [ Ссылка ]


Disclaimer:
Due to factors beyond the control of Ratchetsand Wrenches, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Ratchetsand Wrenches assumes no liability for any property or personal damage that may arise from doing a repair on your vehicle after watching any of my repair video's. Due to factors beyond the control of Ratchetsand Wrenches, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Again Any injury, damage or loss that may result from improper use of tools, equipment, or the information contained in this video is the sole responsibility of the user and not Ratchetsand Wrenches.

свернуть