Side notes, start by supporting the subframe with the wheels on the ground, then remove the two rear bolts then finally remove the 18mm subframe bolt. Use a 2-3ft breaker bar on the 18mm bolt, careful as these bolts can rust and get thinner near the head, if the bolt seems stuck it's better not to force on it as it may break.
When placing back the bracket, tighten first the 18mm bolt (stretch bolt, replace by new, 75ft.lb/105nm plus 120 degrees) then the two 14mm bolts (36ft.lb/50nm the center bolt may have grease on threads careful not to over tighten).
Then remove the jack from under the subframe.
[ Ссылка ]
