This week, we're going to be looking at setting up air-assist and exhaust on a 50w CO2 laser engraver I recently purchased. This machine is similar to the popular k40 laser cutter and other Chinese laser engravers, so the setup process should be similar on most of them.
This video second in a series of videos I'm doing on co2 laser engravers. Future videos I'll be covering everything from cooling your eBay laser engraver to what software to use on your laser engraver machine.

Check out other videos in this series -
Chinese CO2 Laser Engraver / 50w Laser Cutter Guide Ep. 1: [ Ссылка ]
CO2 Laser Engraver Water Cooling & Laser Chillers. Beginner Series Ep. 3: [ Ссылка ]
CO2 Laser Software / K40 Whisperer & Inkscape / Beginner Series Ep. 4: [ Ссылка ]
CO2 Laser Alignment and How to Clean Laser Lens and Mirrors: [ Ссылка ]
CO2 Laser Focus / Focusing Laser Lens - Laser Engraver Beginner Series Ep. 6: [ Ссылка ]

Other Laser engraver videos -
*********************
How to Make Lasered Engraved Coasters: [ Ссылка ]
Laser Cut Leaves / Laser Engraving Leaves: [ Ссылка ]
*********************
#CO2LaserEngraver #Lasercutter #co2laser

* Official Website [ Ссылка ]
* Follow on Instagram - [ Ссылка ]

свернуть