Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: [ Ссылка ]
SUPPORT ME ON PATREON at: [ Ссылка ]
THIS IS MY FULL TIME JOB. Here are other ways that you can support me: [ Ссылка ]
---
If you've got a Naked GoPro, you can start and stop recording using an aux switch on your controller. Here's how to set it up!
--- TABLE OF CONTENTS ---
0:00 - Intro
0:40 - Read the freaking manual? No.
[ Ссылка ] - Insta360 SMO4k vs. GEPRC Naked Hero 8 which is better?
1:32 - Step 1: Decide which pad to use for the signal wire
3:08 - Step 2: Back up your config!
3:58 - Step 3: Find the pin number that goes with your signal pad
5:09 - Check if you have any pre-existing pinio resources
6:23 - Step 5: Assign pinio resource to the signal pad
7:11 - Check if you have any pre-existing pinio_box set up
8:07 - Step 6: Set up pinio_box
9:28 - Step 7: Set up aux mode
[ Ссылка ] - How to set up aux modes
10:36 - This function actually doesn't work like you probably think
Link to my in depth pinio tutorial will be here when it releases.
![](https://s2.save4k.ru/pic/84X9sQJOg6A/maxresdefault.jpg)