In this video you can watch me make a zero clearance insert for my Kobalt KT1015 tablesaw. It is very simple to make with 1/8 inch hardboard and a scrap piece of 1X4 select pine. I first traced the stock insert on to the hard board and then cut it out a little oversized so I could then sand it down to fit snug. Next I measured the opening in the saw and cut the peice of 1X4 to fit. I had to sand down the area that would fit around where the arbor for the blade comes up but that was all I had to do to the 1X4. I also sanded a little off of the hardboard where it meets the adjustment screws so i would have room for adjustment. Next i glued the 1X4 to the hardboard, clamped it up and let it sit. Once that was dry i fliped it long ways and raised the blade up through it, drilled a hole big enough to put a finger through and it was done! Thanks for watching. Please like, comment and subscribe!

Thanks
Brandon Morgan

свернуть