We Install a bonnet guard on our Suzuki Jimny. The process is similar for most vehicles.
A bonnet guard is an acrylic cover that fits to the front of your bonnet, to protect your windscreen and bonnet from stone chips, bugs and road debris. Not only does it enhance the look of the front end it may also save you costly paint and glass repairs.
Chapters
0:00 Introduction
0:11Demonstration
0:15 Introduction continue
0:25 Installation
Installation:
Step 1
Clean above and underneath of the bonnet with damp cloth this is to ensure proper adhesion of the anti-abrasive stickers.
Step 2
Dry above and underneath of bonnet with clean cloth.
Step 3
Remove protective film from bonnet guard.
Step 4
Align bonnet guard holes to holes underneath bonnet. Place the large metal clips to test fit alignment. You can also use the bonnet latch and center indent on the bonnet guard as a marker for alignment.
Step 5
Using a pencil make an indication of where we are going to install the anti- abrasive stickers. Use the bonnet guard holes as a guide and draw a pencil mark in line with the holes underneath the bonnet.
Step 6
Wipe the area with alcohol wipe provided. Be careful not to wipe away pencil marks.
Step 7
Apply rectangular anti-abrasive stickers to cover both top and under paint of the bonnet. This is for placement of the metal clips. Folding the sticker in half makes this easier to achieve an even placement. This is where the pencil marks came in handy.
Step 8
Place the large metal clips on top of the anti-abrasive stickers. Attach the grey plastic clips and metal screws to underneath of bonnet. Tighten metal screws.
Step 9
Place the small metal clips on top of anti-abrasive stickers. There's no screws here as these clips are super tight.
Step 10
Remove bonnet guard and attach black plastic clips to the top of the 4 metal clips.
Step 11
Install the bonnet guard back in place and attached the 4 metal screws and 4 washers. We re-aligned it by measuring the distance at end of the bonnet guard to the bonnet and the fender join. We have a little bit of room to play with.
Step 12
Apply the smaller square anti-abrasive stickers to the bonnet so that it aligns with the underside of rubber heads attached to the bonnet guard.
Step 13
Do one final check. Tighten metal screws.
SUZUKI JIMNY BONNET GUARD INSTALLATION
Теги
4x4suzukijimnysuzukijimnycapetownsouthafricayoutubeyoutubergoprogoprohero10hero10adventurelifeafterthirtynew suzuki jimnysuzuki jimny off roadoff roadoffroadglxepicgoprogopro hero 10 blackbe a heroactionhdhd videobrabusmercedesg63gwaonbodykitmodsaccessoriesdiycarbuildhoodprotectorbonnetguardacrylicstyle