for data recovery call: 855.366.4232
or request your service here: [ Ссылка ]
music: [ Ссылка ]
this video: [ Ссылка ]
This hard drive was found after the fire, but it acquired most of the damage from the water as the fire was being put out. Seals on this drive held up. It is very important not to power up hard drives without proper inspection. If gaskets would have failed and the liquid did get inside of the unit, the results of powering it up would have been catastrophic for data. In this case, we've swapped out the chassis and PCB to with donor ones. PCB had too much corrosion on it, and we did not feel like taking a risk on burning up a preamp. Besides, there is no shortage of Hitachi PCBs in our lab :)
The disk was cleaned (from appeared to be smoke contamination) and the original head assembly looked clean and was used again.
After the assembly of this hard drive, we moved onto the work with PC3000. Disk imaging process very well, and we were able to obtain a full copy of data
if you want to ship your failed device to us for data recovery and free evaluation, simply fill out this form: [ Ссылка ]
and send your drive boxed with bubble wrap to this address:
HDD Recovery Services
391 Bank St, Suite 201
Ottawa, ON
K2P 1Y3
Canada
my gear for soldering:
Microscope: [ Ссылка ]
Multimeter: [ Ссылка ]
Microscope camera: [ Ссылка ]
Capture card recording device: [ Ссылка ]
Soldering iron station: [ Ссылка ]
Microsoldering iron: [ Ссылка ]
Hot air station: [ Ссылка ]
Infrared preheater: [ Ссылка ]
Flux: [ Ссылка ]
Wick: [ Ссылка ]
Solder: [ Ссылка ]
Gloves: [ Ссылка ]
Fume Extractor (mine is no longer available but this is the new version of the same unit) : [ Ссылка ]
Gear for filming:
small camera: [ Ссылка ]
big camera: [ Ссылка ]
Lens on big camera:[ Ссылка ]
