WARNING: RUNNING HHO GAS UNDER PRESSURES HIGHER THAN 12 PSI IS EXTREMELY DANGEROUS! REPLICATING THIS HHO GENERATOR IS AT YOUR OWN RISK.
See our green energy non-profit here: www.lablancinventions.org
Brown's gas
HHO, Hydroxy Gas:
WARNING: COMPRESSING HHO GAS ABOVE 12 PSI HAS BEEN KNOW TO SELF IGNITE AND HAS INJURED AND KILLED SOME FOLKS BEFORE. THE WATER / NAOH (SODIUM HYDROXIDE) MIX IS EXTREMELY CAUSTIC AND WILL CAUSE BLINDNESS IN 15 SECONDS IF THIS WATER MIX GETS IN YOUR EYES. ALWAYS HAVE A STRONG THICK POLYCARBONATE SHEET / BLAST WALL IN FRONT OF THESE EXPERIMENTS AND WATER TO WASH YOUR EYES / FACE WITH IN CASE OF ACCIDENT. ALL EXPERIMENTS USING OUR INFOMATION PROVIDED YOU IS AT YOUR OWN RISK. THE WATER MIX AT HIGH TEMPS IS DIFFFICULT TO CONTAIN IN SILICONE RUBBER HOSE EVEN 4 PLYS THICK. ALL CONNECTIONS SHOULD BE STAINLESS STEEL PIPES AND NOT HOSE. PLASTIC TUBING IS TOO SOFT TO HANDLE THE HEAT. THE O-RINGS SHOULD HANDLE THE CAUSTIC CHEM MIX AND EXPECT THEM TO WEAR OUT FAST.
high pressure HHO Chemical reactor is used to bring up distilled water and NaOH (sodium hydroxide) and HHO gas to 100 psi at 80-200F. the single 24 inch long x 3/4 inch diameter stainless steel tube cell patterned after Stan Meyer's, is driven by dual cables of 1/2 wave DC at 3-5 VDC at 200-250 amps. Cell runs 140-280F at 200 amps and 4 VDC. This is a dangerous and fussy system. The system exhibits a "heat cycle" behavior. The output end of the cell runs the hottest at approx. 200-300F, the input end of the cell runs at 100-200F, the reactor tank temp at the top of the unit runs 80-180F, the bottom of the reactor tank runs 80-140F. The max. amps run thru the circuit that seems to be the sweet spot is 200 amps at 3.0 to 4.0 VDC dual half wave power supply. The power draw of the system is from 600-900 watts. the resistance of system (including the catalyst in the water) is .014 to .018 ohms.
Note: this dangerous high pressure HHO system was inspired by the work of Fast Freddy the gun maker from Arizona. Check out our "Micro torch" video and see what happens to this system when pressure is not allowed to build. it will amaze you!
_______________________________
Update 4/21/2017
designing a single cell now, it's a 4 inch stainless steel tube for outside cell wall and 3.5" ss inner tube cell. that's 127 cubic inch surface area. this old cell in this video is only a 37 cubic inch single cell. it produces 2 liters per minute of high quality HHO gas as noted by 6 inch flame. this is a phenomenal event. Never heard of anything capable as this video shows. This new cell will be part of the reactor tank as pictured in this video. the tank and cell will be one and the same. this will solve a lot of leakage and safety issues.
