When you are planning the layout of the metal roofing panels you will need to cut and bend the first and last sheet of standing seam metal roofing. After you cut the metal roofing panels, they will need to be bent upwards with a Woku roller bender. In this video, we will give you step by step standing seam metal roofing installation instructions.

00:00 How to fold standing seam metal roofing
00:26 How to cut standing seam metal roofing
03:00 How to bend standing seam metal roofing
03:40 How do you use a Woku bender?


If you already have not purchased your standing seam metal roof, give us a chance to bid your job. Save 15% to 50% with our manufacturer direct pricing and great customer service. Inexpensive delivery anywhere within the United States.

Visit Our WEBSITE
[ Ссылка ]

Standing Seam Metal Roofing Panels
[ Ссылка ]

Standing Seam Metal Roofing Installation Series
[ Ссылка ]

How To Layout Standing Seam Roofing Panels
[ Ссылка ]


Marking and Cutting Your Standing Seam Panel
In most installations, you’ll need to cut the last panel down. For this example, we will cut a 18” panel down to 11”.
To cut down your standing seam panel:
1. Make your first mark at 11” for a fold line.
2. Make a second mark at an additional 1 ¾” for the cut line.
3. Do the same procedure on the opposite side of the panel.
4. Chalk or trace a line across the cut mark depending on the size of your standing seam panel. TIP: Only make your cut line mark initially to help prevent cutting mistakes when multiple installers are on a site.
5. Take your double cuts and align the blade to the left or the right side of the mark.
6. Cut through your panel.

Folding A Standing Seam Panel With A Woku Roller Bender
Now that we have our cut, it’s time to create the fold line on the panel.
1. Mark your fold line on your panel just like you marked your cut line above.
2. Make a small notch on the fold line to help the panel bend easier.
3. Take a Woku roller bender and set it at 1 ¾” depth and double-check with your tape measure.
4. Flip over the metal roofing panel.
5. Run the three wheels down and the single wheel up. TIP: Avoid one-wheeled roller benders as they don’t stay square on the panel.
6. Set your Woku bender on your depth and roll the panel.
7. Start with a slight crease and gradually bend as you go TIP: Clamp the panel down or have an assistant secure it to make the bending process easier.
8. After using the Woku bender, additional adjustments can be made using your hand seamer or by hand to get it to a straight 90 degrees


FOLLOW US ON SOCIAL MEDIA:

FACEBOOK: [ Ссылка ]
INSTAGRAM: [ Ссылка ]
TWITTER: [ Ссылка ]
LINKEDIN: [ Ссылка ]
HOUZZ: [ Ссылка ]
PINTEREST: [ Ссылка ]
YOUTUBE: [ Ссылка ]

Visit our LEARNING CENTER
[ Ссылка ]

свернуть