This clever magnetic 90 degree saw guide for woodworking makes it easy to cut straight every time. Please Subscribe if you like this video - thank you!
🔨 LINKS TO TOOLS AND PRODUCTS I USE IN THIS VIDEO*
🔸 Kataha Tatebiki Z Saw 10" Single Edge Rip Saw - [ Ссылка ]
🔸 Neodymium 10mm x 2.6mm magnets (I used 3mm but 2.6mm will work just as well) - [ Ссылка ]
🔸 Brush On Liquid Super Glue - [ Ссылка ]
🔸 2 Part Epoxy, 5 Minute Set - [ Ссылка ]
🔸 Machinist Ruler, 12in - Metric and Imperial - [ Ссылка ]
🔸 Forstner Bit, 10mm (25/64-Inch) Diameter, 8mm Shank - [ Ссылка ]
🔸 DEWALT 20V MAX Cordless Drill / Driver Kit, Brushless, 1/2-Inch, 110V charger version - [ Ссылка ]
🔸 Woodworking Chisel Set - [ Ссылка ]
🔸 IRWIN Woodworking Vise, 6-1/2-Inch - [ Ссылка ]
🔸 DEWALT 10-Inch Table Saw, 32-1/2-Inch Rip Capacity, 110V model - [ Ссылка ]
* I might receive a small commission on any purchases made through the affiliate links above. Thank you for supporting my channel while it grows 🙂
You can read more about this saw guide at the following blog post on my website: [ Ссылка ]
This saw guide works for both 90 degree rip cuts and cross cuts.
Materials required:
- Hardwood of medium to high density. I used heart Rimu but Walnut is another good option.
- Neodymium magnets (rare earth) 10mm x 3mm [3/8" x 1/8"]
- Super glue
- 5 minute epoxy
- Wood finish (I used my chopping/cutting board conditioner which is made from mineral oil and beeswax)
Tools required:
- Saw (hand saw or table saw)
- Chisel
- Electric drill
- 10mm [3/8"] forstner drill bit
- Mallet
---------- Tags ----------
#woodworking #magnetic #cutting
---------- Music ----------
"Acoustic guitar arrangement for song" by Trev Row
[ Ссылка ]
![](https://i.ytimg.com/vi/BFCjpxclFBM/maxresdefault.jpg)