If you've tried 3d printing a ball joint, like the ones use in PrintABloks, you may have run into a problem. The joints start out fine, but over time they loosen. Fortunately there's a couple of solutions you can employ, and Cymon and I will tell you all about them.
3D Printing Professor is made possible by YOU!
[ Ссылка ]
I'm social!
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]
Buy the Beginner's Guide to the 3D Printing Galaxy on Amazon: [ Ссылка ]
Shop on Amazon to support the channel: [ Ссылка ]
Follow my other 3D printing adventures at: [ Ссылка ]
Join the mailing list and never miss anything important: [ Ссылка ]
00:00 Why are my joints loose?
05:13 Solution : Bluetak
06:30 Solution 2 : Swap for Tighter
07:38 Solution 3 : Nailpolish
08:38 Solution 4 : Print in PetG
09:23 3D Print to Win
![](https://i.ytimg.com/vi/Bb7Mi97DNHs/maxresdefault.jpg)