I was using a dado stack and instead of replacing the zero clearance throat plate with the dado stat throat plate I ran the dado stack through the wrong one. Thinking I could just keep using it with out issue, welp I was wrong. So with the encouragement of Cow Dog Craft Works, I went to the ol YouTube and found Stumpy Nubs' video on how to make one. So that is what I did and to my surprise it was really not that hard. I made one for my SawStop but this process can be used for any saw, just have to make sure to test fit often.
Cow Dog Craft Works
[ Ссылка ]
Stumpy Nubs
[ Ссылка ]
Amazon Associate links
Making Time, By Bob Clagett
[ Ссылка ]
Relitec Positioning Squares
[ Ссылка ]
Feiyang Miter Springs
[ Ссылка ]
Bora WTX 5 Pc Clamp edge saw set
[ Ссылка ]
Bora 24" Parallel Clamps
[ Ссылка ]
GoPro Hero 5 Black
[ Ссылка ]
MicroJig GRR-RIPPER
[ Ссылка ]
25 ft Milwaukee Tape Measure
[ Ссылка ]
Rigid Cordless Set
[ Ссылка ]
Kreg Jig
[ Ссылка ]
Titebond II
[ Ссылка ]
[ Ссылка ]
Knipex Pliers
[ Ссылка ]
Saw Blade
[ Ссылка ]
EDC Pouch [ Ссылка ]
DISCLAIMER: Woodworking and the use of power and hand tools can be extremely dangerous. You are responsible for understanding the safe use of your tools and techniques. Your safety is YOUR responsibility, I accept NO responsibility or liability for any injuries, accidents, death occurring to you or others if you attempt to do the things that I do or use advice that I give.
Ещё видео!