Instructions are terrible
Missing a page with two steps. The missing steps are nearly the whole drawer assembly - a very important part of the assembly.
The instructions show using screy H to secure the power outlet which is incorrect. The two little screws labled "I" should be used to secure the power outlet to the furnature.
The instructions should go a little further to make sure that pieces are oriented properly. Directional arrow stickers on the pieces themselves showing "top" and "front" would have helped.
Here are some tips on installation.
1. Use screws "i" to attach the power outlet to the top. The instructions will say "h" but this is incorrect.
2. The draw asembly instructions are missing, but if you can asseble if you understand that you will use screw "g" into the sides of pieces 8 and 9 into piece 10 with the drawer slides on the outside lining up the grooves for the drawer bottom on the inside.
3. It is easy to put pieces together incorrectly, but if you take your time and constantly check orientation in the instructions you will be able to figure it out. Pay careful attention to the finished edge of piece 5 when attaching to piece 2 and piece 3. Also pay particular attention to the top and bottom as it is easy to accidently switch these which will fail to work even though it might look correct until the drawers go in (but not correctly).
Suggestions for SinCiDo
The whole in the back of the furnature for the power cord really should be closer to the top of the piece so it is harder to notice when looking at the furnature.
Fix your instructions as per the above.
Tighter quality controls are needed on the alignment of drilled holes. Some are imprecise.
Praise
Great job packing the pieces in the box. The hard pieces around the adge of the box and thick rubber corners probably save this from getting destroyed in transit.
Ещё видео!