I will show tips and tricks for printing thin wall with this Artillery Sidewinder direct drive printer. I also print a full 3D printed RC airplane and give a review on the process.
Spool Holder STL: [ Ссылка ]
Thank you so much for watching!

If you like videos like this, consider buying me a coffee, it really supports me: [ Ссылка ]

See what else I am working on:
[ Ссылка ]
[ Ссылка ]

#3Dprinted,#RCairplane, #Artillery

Aliexpress store link：[ Ссылка ]

Artillery 3d official website: [ Ссылка ]

STL Files for the ASK14 Glider: [ Ссылка ]

How to Print Thin Wall: [ Ссылка ]

Thank you to Artillery for sponsoring this video!


*These are the settings I used for this Artillery Sidewinder X1 with Overture PETG. These may not work exactly for you, but should give you a good base to start with if you have a similar size printer. Good luck!

Profile 3 Cura Settings:
Quality:
Layer Height – 0.25
Line Width – 0.4
Shell:
Wall Line Count – 1
Infill:
Infill Density – 0
Material:
Printing Temperature – 240
Build Plate Temperature – 60
Flow – 100
Enable Retraction – Checked
Retraction Distance – 1.3
Retraction Speed – 10
Retraction Extra Prime Amount – 0.2
Speed:
Print Speed – 100
Outer Wall Speed – 35
Inner Wall Speed – 35
Travel Speed – 100
Travel:
Combing Mode – off
Cooling:
Enable Print Cooling – Checked
Fan Speed – 50
Mesh Fixes:
Union Overlapping Volumes – NOT Checked
Special Modes:
Surface Mode – Surface
Experimental:
Slicing Tolerance – Middle








Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Thank you for your support!!

свернуть