When I was running the CNC Router I noticed it did not router the two cross dados. So, I left the board in the CNC fully clamped. Then went back to the computer, pulled up the vCarve file where I could see I simple never set up the path to run the two dados. So, rather than starting a new file I used the existing, created the dado toolpath, ran a test on screen but then, instead of saving all 7 of the toolpaths I saved only the dado one to the .tap file. Since it was caught before removing the board/clamps I only need to run the dado path.
This video is part of an Instructables.com by Door County Rustic
This video is part of a series of tutorials about incorporating "knock-down" functionality into woodworking projects using Mike's patented Threaded Tenon Joinery. For more info check out ThreadedTenonJoinery.com
![](https://i.ytimg.com/vi/DHLfVHlkGP8/maxresdefault.jpg)