Installing air compressor lines / Shop / Garage Air System in the House of Chop, including a gravity based air drying manifold / after cooler. This is one of the most simple and effective ways to get clean, dry air throughout your shop. I take you through the process of building a 3/4” copper system and explain how it works.
It’s important to keep the lines of your air compressor dry, you don’t want moisture ripping up your equipment and causing rust inside your tools. It’s especially important for plasma, sand blast setups, and any paint or powder work.
-----------------------------------------------------------------------------------------------
House of Chop behind the scenes: [ Ссылка ]
The Chop Shop: [ Ссылка ]
Website: [ Ссылка ]
🙇🏻♂️To Support the Channel: [ Ссылка ] 🙇🏻♂️
Chop's favorite things:
[ Ссылка ]
HTP Invertig 221 Welder: [ Ссылка ]
Welding supplies & machines: [ Ссылка ]
-----------------------------------------------------------------------------------------------
Things I Used in This Project:
Ryobi Drill/Driver: [ Ссылка ]
Brass Pipe Fitting 1/2" NPT Female: [ Ссылка ]
Hex Nipple, 1/2" x 1/2" NPT Male Pipe: [ Ссылка ]
1/2-Inch I.D. by 3-Foot Rubber Lead-In Air Hose: [ Ссылка ]
Husky Tubing Cutter: [ Ссылка ]
Bernzomatic Torch: [ Ссылка ]
Copper Pipe Cleaner: [ Ссылка ]
Hose reel: [ Ссылка ]
A few links to videos I found helpful:
Jimbo’s Garage: [ Ссылка ]
Busted Classic Garage: [ Ссылка ]
Jeff Willard: [ Ссылка ]
The Wizard: [ Ссылка ]
Sam’s Garage: [ Ссылка ]
Eastwood Scroll Compressor Item 32200
[ Ссылка ]
Eastwood Air C.F.S. (Complete Filtration System) Item 31633
[ Ссылка ]
#houseofchop #shopairlines #aircompressor
![](https://i.ytimg.com/vi/DPX48WuaIhw/maxresdefault.jpg)