Need to rearrange your motors? Or want to fly with a "pusher" quad? In this video I'll show you what I did to fly with a normal quad setup (wizard X220), just with everything upside down, and I'll do my best to explain MOTOR MAPPING in Betaflight.
Joshua Bardwell's Resource Mapping video [ Ссылка ]
TABLE OF CONTENTS:
1. Motor Mapping 1:50
2. Board Orientation 12:00
3. Check physical motor spin direction 14:04
4. Set "mixer" motor spin direction 14:46
5. TEST without props 15:20
6. Attaching propellers 15:52
7. Reversing motor direction (if needed) 16:43
COMMENT BELOW Do YOU fly a quad like this?
Support RCwithAdam by purchasing through these links!
Amazon [ Ссылка ]
Banggood [ Ссылка ]
I have a website [ Ссылка ]
-------
RC with Adam GEAR
RADIO: [ Ссылка ] [ Ссылка ]
QUAD RECEIVER: [ Ссылка ] [ Ссылка ]
AIRPLANE RECEIVER: [ Ссылка ] [ Ссылка ]
QUAD PROPS (my fav) [ Ссылка ] [ Ссылка ]
RC with Adam FILMING GEAR
Main camera [ Ссылка ]
Action Camera [ Ссылка ]
Mic [ Ссылка ]
Camera stand [ Ссылка ]
--------
Mandatory Disclaimer:
I participate in the Amazon Affiliates program, which means that if you click on one of the above Amazon links and purchase a product on Amazon, I will receive a teeny tiny commission (at no additional cost to you). Also, various other links listed here may be affiliate links, to which this disclaimer also applies.
**REMEMBER, always use caution and your best judgement when building and flying RC aircraft, be a good neighbor, and HAVE FUN!**
-----------
About RC with Adam: Adam makes FUN and HELPFUL videos about Radio Controlled aircraft, tech, and DIY projects! #RCwithAdam
Ещё видео!