This video brings the overarm support project to its conclusion. The bore for the bearing journal bush is machined to size. The bronze bush is pressed into place and the whole assembly is given a running test.
The combined bending and torsion calculations made in video #9 are briefly reviewed and tested with baggage scales and a DTI. The result is remarkably close the calculated figure.
00:00 Introduction
01:24 Setting up for boring overarm bearing
05:54 Boring for bearing bush
08:35 Fitting of bush
12:05 Testing fit of bush with journal
13:45 Final fitting of bush
15:19 Final test
16:19 Checking deflection of overarm - bending & torsion calculation
18:09 Review of this project
Related video on producing the casting for the support bracket: [ Ссылка ]
