Replacing an Accord Wheel Bearing
Ok, here it is finally. A few of you have requested this procedure so here it is. As I said in the video I normally use a different method of removing the hub from the bearing assembly by using a slide hammer. I also normally use a press to reinstall the hub into the new bearing instead of hitting it with a hammer. Life is not perfect and we sometimes have to improvise as I did here. I know a few of you will ask about the size fasteners that I used to hammer the bearing out, I used hardened (8.8) 10x1.25 bolts to do the job. I also promised links to the other videos that relate to this one so here they are.
"Oops, Axle Ball Joint Replacement"
[ Ссылка ]
and also "How to Replace Honda Captive Rotors"
[ Ссылка ]
---
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
[ Ссылка ]
Visit EricTheCarGuy Forum
[ Ссылка ]
Visit my Facebook Page:
[ Ссылка ]
---
Thanks again to all that have subscribed and left such great comments on my videos and my channel, you are the best, I mean it.
You know the line
Stay dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.
