I needed custom doors for my basement because of the low ceilings. Unfortunately when you order short doors, the factory just cuts the bottom off leaving a door that is very unproportional. I didn't want to spend the time or money building frame and panel doors, so after a week of racking my brain I came up with this method. Each door cost less than $50.00

Check me out on social media:

Facebook: [ Ссылка ]
Instagram: [ Ссылка ]
Patreon: [ Ссылка ]

Track Saw
[ Ссылка ]

Flush Trim router bit
[ Ссылка ]

Rabbet Bit
[ Ссылка ]

свернуть