ALTERNATING CABLE CAST ON 1X1 RIBBING
This is a variation of the Cable Cast on, but includes the purl stitch cast on for ribbed edges. This can also be done as a 2x2 ribbed cast on. This edge is also neat and firm for edges that don't require a lot of give.

STEP 1:
Make a slip knot, leaving a 4 inch tail, and place it on a needle in the left hand.

STEP 2:
Knit into the slip knot, leaving the slip knot on the left-hand needle.

STEP 3:
Slip the new stitch back to the left-hand needle knitwise.

STEP 4:
Bring the yarn around the front. Reaching behind the left-hand needle, insert the right-hand needle between the 2 stitches, warp the yarn around as if to purl and pull the stitch through.

STEP 5:
Slip this new purl stitch to the left-hand needle knitwise.

STEP 6:
Bring the yarn to the back. From the front, insert the right-hand needle between the end most 2 stitches, wrap the yarn around, and pull the new stitch through. Slip this new knit stitch to the left-hand needle knitwise.

STEP 7:
Repeat steps 4-6, alternating between knit and purl stitches until the desired amount of cast-on stitches. The new stitch will always be made by going between the 2 stitches closest to the tip of the left-hand needle.

For More Info Visit: [ Ссылка ]

свернуть