Few months ago I installed linear rails on Ender-3 V2 but only on Y and Z axis. On X axis an earlier installed MicroSwiss extruder can be used only with V-slot wheels. But new NG extruder can be bought in variant which can be used with linear rails too. Additionally, this extruder has the gear ratio 3:1 and very small pulley-hotend distance, which makes it great extruder for 3D printing with flexible filaments.
MicroSwiss extruder: [ Ссылка ]
Linear rail kit on Banggood: [ Ссылка ]
Linear rail installation video (Y, Z): [ Ссылка ]
Old extruder installation video: [ Ссылка ]
20 mm D6 dice and clibration cube: [ Ссылка ]
Chapters:
0:00 Introduction
1:16 Unboxing
2:16 X Linear rail installation
4:50 Installing the extruder
12:31 E-steps, Z offset
13:43 3D printing
14:18 Conclusions
#ender3v2 #ender3upgrade #microswiss
