SSH
Back to Top
If you can SSH into the AP, it's possible to do L3-adoption via CLI command:
1. Make sure the AP is running updated firmware. If it is not, see this guide: UniFi - Changing the Firmware of a UniFi Device.
2. Make sure the AP is in the factory default state. If it's not, do:
sudo syswrapper.sh restore-default
3. SSH into the device and type the following and hit enter:
set-inform [ Ссылка ]
4. After issuing the set-inform, the UniFi device will show up for adoption. Once you click adopt, the device will appear to go offline.
5. Once the device goes offline, issue the command set-inform in step 3 again. This will permanently save the inform address, and the device will start provisioning.
![](https://s2.save4k.ru/pic/HsO-Bwvhkyc/maxresdefault.jpg)