I use the H.W. Kearns horizontal bowing mill to set up and bore out the center of the two large gearbox stands I recently fabricated. There was a mistake made on some drawings and the incorrect dimensions were given when burned out. Instead of making a mess of them with a torch, or wasting material, I set them up in the mill and bored them out as needed.
In the mix I also show my dads Starrett 2-32" Starrett inside mic, as well as his Starrett 36" vernier calipers, which I use to measure the bore.
SNS 164 Part 2: Horizontal Boring Mill
Теги
abom79horizontal boring millh.w. kearnskearns boring millkearns horizontal boring millmachine shopmachiningheavy machiningabom79 machiningheavy duty machiningboring large partslarge boring millgearbox standslarge gearbox standsmanual machiningold school machining.starrettinside micstarrett inside micvernier caliperstarrett vernier caliper36 inch vernier caliper