First service of the FF-13 Chinese mini excavator.
Noticed the machine was a little more “loose” than normal so I pulled the floor board and inspected the swing motor only to find the mounting bolts had rattled themselves out almost completely.
Tool I recommend is a 8mm or 5/16” ball end extended length 3/8” drive hex bit (or what ever you decide to call it).
The oil change is dead simple, I ended up using a total of 1L or 1qt whichever measuring system you you want to use both measurements are close enough for the precision lines cast into the plastic dip stick 🤣
I’m at 40hrs of machine time as I post this video, so far the little machine has been a beast 👍
