This is Part 6 and the final episode of the LH Stinger build, where we assemble the Toolhead, install the aux fans and wiring and connect it up for the first time.

These are rough & ready videos, created with one thing in mind, documenting the build journey of the LH Stinger. Please note that these have minimal editing, and have just been sped up significantly during 'dead space' such as my reading documentation, searching for hardware etc.

Get your LH Stinger Kit here: (Affiliate Links, help us out!)
Fysetc Store: [ Ссылка ]
AliExpress: [ Ссылка ]

See my Documentation Site: [ Ссылка ]
And maybe buy me a coffee: [ Ссылка ]

Useful Links:
@LemurHaze - LH Stinger Creators YouTube
LH Stinger GitHub: [ Ссылка ]
LH Stinger Discord: [ Ссылка ]
Fysetc Discord: [ Ссылка ]
Supplementary Docs: [ Ссылка ]

Chapters:
00:00 - Introduction
00:16 - Z-Stop Bumps
01:19 - Z-Endstop Switch
02:42 - Toolhead Assembly
05:07 - Toolhead Installation
08:20 - X-Belt Tensioner
10:51 - Aux Fan Assembly
12:30 - Breakout Board Install
13:16 - Wiring
13:47 - Outro & Disclaimer

свернуть