A tutorial on how to make a servo motor controller & tester circuit using 555 timer IC and a few other components. This circuit allows us to manually drive/control any servo motor by pressing buttons or by turning knob of a potentiometer.
Link to the project page and circuit diagram: [ Ссылка ]
Components Required
* 555 Timer IC
* Servo Motor
* 1 PN Diode (I used 1N4148)
* 2 Momentary Push Button Switches
* Resistors: 220K, 56K, 10K
* Capacitor: 100nF
* Breadboard
* Few Breadboard Connectors
* (5-9)V Power Supply (Adapt to Servo voltage)
Note: If you wish to control the servo using potentiometer, use a 50K resistor in series with a 1K resistor instead of 56K, 10K resistors and push button switches. Refer to the circuit below for the exact arrangement.
This tutorial is a part of 18 video series on Electronic Projects created using IC 555: [ Ссылка ]
-----------------------------------------------------------------------
For more electronics projects, visit: [ Ссылка ]
Like our Facebook page: [ Ссылка ]
And don't forget to Subscribe!
![](https://i.ytimg.com/vi/J-QO7jQGfoE/maxresdefault.jpg)