Cobra 148 GTL Custom old school Taiwan Edition with the AD-203 stinger board installed....
The amp on/off is controlled by the CB/PA switch..
Very rare 100 watt 148.....
100% of the factory Sonybond corrosive glue was removed from several areas of the board, top and bottom... Installed the AD-203 stinger board and 10 turn unlocked clarifier pot...3 1/2 watt dead key swings to 110 watts on AM and SSB...
Full re-cap, stinger board power leads upgraded to 10 gauge wire, new voltage regs, blue ch display, s-meter led is white on rx and turns red on tx, polarity protection diode and extra noise filter on the power jack coming into the radio
The AD-203 mounting screw holes were drilled and tapped into the heat sink using the factory speaker holes in the cover so there is no extra holes drilled into the covers...
Ещё видео!