Here's the links mentioned in the video:
Julio's (How to make a Barstarzz park:) [ Ссылка ]
And for laying turf:
[ Ссылка ]
------------------------------------------------------------------------------------------------------------
The project took me about a week from start to finish from digging the holes to laying the turf.
Here are some of the things you'll need:
Three, 4x4x10 ft Redwood post
One, 4x4x8 ft Redwood post
One 1in x 8 ft Galvanized Pipe
(For pull up bar and top human flag bar)
One 1in x 5 ft Galvanized Pipe
(For shorter pull up bar)
Three 1in x 2 ft Galvanized Pipe
(For human flag bars)
Two, 1 1/4 inch 10 ft Galvanized Pipe
( For dip bars, Home Depot will cut it upon request for free)
Two, 1 1/4 90 degree elbow joint
(for dip bars)
----
Two 1 1/4 flange
(Connects to the 4x4 by10
and into the dip bars)
Eight 3/8 16 x 6 Hex Bolts (dip bars)
Eight 3/8 16 x 1 1/2 Washer
Eight 3/8 Hex Nuts
Nine 3/8 16 x 4 To hold poles from possible movement (Optional)
Nine 3/8 16 x 1 1/2 Washer (Optional)
Nine 3/8 Hex Nuts (Optional)
(To drill through both wood and metal
you'll need a titanium nitrate drill bit)
10 bags of Concrete.
1 container of water resilient wood stain. (Optional)
----
First I connected the 8ft top bar into all three 4x4 by 10 wood posts. Then I drilled holes and connected the 3 human flag bars.
I dug Three 2ft holes for the posts and raised it up (I put rocks in the holes to hold the posts together) then poured about 1 1/2 bags into each hole.
Later that night I dug the two holes for the dip bars.
connected the threaded galvanized pipe into the elbows and connected the other threaded ends to the flanges on the 4x4 by 10 wood posts.
I put rocks to hold the dip bars in place and poured 1 1/2 bags of concrete in each hole on top of the rocks.
The same night I also made the 2 ft hole for the 4x4 by 8 ft post
about 5 ft away form the 4x4 by 10 ft post. I connected the flange then installed the last 5 ft smaller pull up bar and I was done for the day.
The next day I cleared the ground of any loose gravel and laid down some crushed gravel. I lightly watered it down and compressed the gravel with a roller. I covered the crushed/compressed gravel with weed barrier. I laid out my grass turf in the sun for a couple hours before pulling it over the area I wished to cover and began to cut the shape I wanted along the plastic grass liner. I nailed it down on some ares with 6 inch nails to help secure the turf. I put some sand into the fibers of the turf and brushed it through to help it stand up. Then I was done!
Any addition questions feel free to leave a comment below and
Thank you!
----------
I do not own the rights to these songs used in the video:
Artist: Crashbomb
Song: Jello mold struggle
Artist: Kryder
Song: Crocodile Tears
Artist: Weird at last
Song: No man sky
