To drill the set screw holes for a pillow block insert ball bearing, follow these steps:
1. Place the pillow block on a stable work surface with the mounting surface facing upwards.
2. Measure and mark the location for the set screw holes using a marker or punch tool. Refer to the manufacturer's specifications for the recommended hole spacing and depth.
3. Use a drill bit that is slightly smaller than the diameter of the set screw to make pilot holes at the marked locations. Make sure the bit is centered over the mark to ensure accurate drilling.
4. Drill the set screw holes to the recommended depth using a larger drill bit. Use caution not to drill too deep or damage the bearing housing.
5. Clean the holes with a brush or compressed air to remove any debris or metal shavings.
6. Insert the set screws into the holes and tighten them to the recommended torque using a torque wrench.
7. Check the alignment of the bearing and make any necessary adjustments before using the equipment.
#bearing #bearinghousing
web:www.bearingfamily.com
Ещё видео!