I create all this content for the greater good with everything licensed under Creative Commons. At the same time your support is genuinely appreciated- tips are welcome via this link:
[ Ссылка ]
This video demonstrates three simple Arduino sketches configured to monitor an Argent wind vane, tipping bucket rain gauge, and a cup anemometer for future integration with cellular and satellite remote environmental monitors.
The wind vane sketch was developed from scratch, whereas the tipping bucket and cup anemometer sketches are derived from the Arduino library written by John Cape for interfacing with Argent's Wind and Rain Sensor Assembly.
Sensor 1- Wind Vane: 1:47
Sensor 2- Rain Gauge: 14:30
Rain Gauge Mechanics: 16:33
Rain Gauge Electronics: 17:27
Tipping Bucket Tests: 21:23
Reed Switch Bounce: 22:07
Debounce Constant Test: 22:56
Hall Effect Sensors: 25:36
Hall Effect Sensor Test: 26:18
Hardware Noise Filter and Test: 28:50
Demonstration of RC-Schmitt Trigger Circuit: 32:36
Sensor 3- Cup Anemometer: 33:53
Conclusion: 37:11
Links of Interest:
Argent Arduino Library:
[ Ссылка ]
Argent weather station:
[ Ссылка ] [ Ссылка ]
Argent weather station with micro controller:
[ Ссылка ]
Code and spreadsheets mentioned in this video:
[ Ссылка ]
This video updates chapter 9 based on a review of Argent's library and Hall effect Sensor tests: [ Ссылка ]
New to Arduino? Start here: [ Ссылка ]
Guitar by Frederick Noad – [ Ссылка ]: “Study in A minor”
Concluding track by Tom Glazer – Weather Songs (Goodwill find on vinyl) – “Why does the Wind Blow?
Update 3/31/2020: Please see comments section regarding update in video.
