Quick down and dirty video of an N scale Kato SD80MAC that has had an ESU Nano V5 58923 installed.

Frame has been machined to accept this and a 15x8mm speaker and 3d printed housing. Factory light board is sliced up and original led's replaced, along with front light tubes being clipped and separated. Those are controlled by Aux1 and Aux2 wired to dropping resistors and 0502 smled's with wired leads.

ESU sound file S0811 for the SD80MAC is installed.

Install in a Kato SD90 would be similar, except a slightly different sound file and depending on road, if alternating ditchlights weren't needed, I probably wouldn't waste the time installing additional LED's and just leave the ditchlights attached to the factory light pipe.

I will post some of the still photos of the install on my facebook page.

Questions? email me at kelley@dufordmodelworks.com

or visit me over at www.facebook.com/dufordmodelworks

or the original site at www.dufordmodelworks.com

Thanks for watching and have a great day!

свернуть