Auto turn off/on solar street light.TP4056 module & D882 transistor project | New idea

In this video, you will know how to create automatic solar lights on how to create TP 4056 Module & D882 with transitory

Module performance

Module performance: The input voltage: 4.35-6 v (recommended voltage 5 v) Charge cut-off voltage: 4.2 V + / - 1% Maximum charging current output: 1000 ma The battery overcharge protection voltage: 4.28 V Battery overcharge lifting voltage: 4.00 V The battery discharge protection voltage: 3.0 V Battery discharge termination voltage: 3.2 V Battery: over-current protection current 3 a The board size: about 2.5 * 1.65 CM Light state: no load the light not bright, red light for recharging, is full of green light. PACKAGE INCLUDED: 1 X Modules

TP 4056

Simply connect

Charge your lithium battery with the TP4056 Battery Charging Module! Simply connect the ends of the battery to the BAT+ and BAT- terminal of the module and power the module with a 5V power supply from the micro USB port.

Module

the module will cut output power from the battery if the discharge rate exceeds 3A or if a short-circuit condition occurs. Soft-start protection limits inrush current Full-charge voltage: 4.2V



Required

Solar Panel
TP4056 charging module
D882 Transistor
N4007 Diode
1K/10K Resistance
Any 4V LED
3.7V Battery

By now Amazon:-

6v 3w Solar Panel
[ Ссылка ]


TP 4056 Module by link:-
[ Ссылка ]


Digram Link
[ Ссылка ]


If you have enjoyed this video,then please like share comment and don't forget to subscribe


Thank you very much for watching

свернуть